The DMF transmits the engine torque to the clutch pressure plate and the clutch disk. Its primary purpose is to isolate the torsional vibrations generated in the engine, preventing them from passing into the driveline.

The current engine technology places higher and higher demands on clutch systems and the entire driveline. Consumption-optimized truck engines, such as diesel and gasoline engines using direct injection, already develop high torque at low speeds. The usable engine speed range is additionally reduced towards the idling speed level to enable fuel-efficient and low-emission driving. This increases the combustion engine's rotational irregularities. For the driveline and driver, this means increased vibrations, increased noise and reduced comfort. This is where the DMF comes in as a powerful torsional vibration isolator. It helps protect the driveline against harmful vibration and ensures low-noise and comfortable driving.

The SACHS dual-mass flywheel is installed between engine and transmission, together with the clutch pressure plate and the clutch disk.

The flywheel's rotating mass is divided into a primary and a secondary mass. An extremely powerful multi-spring damping system is installed between the two masses.

The SACHS DMF offers numerous advantages, such as optimal vibration isolation across the entire speed range, individual adaptation to the vehicle design, effective noise reduction, smooth setting-off behavior, great shifting and driving comfort, protection of the transmission, excellent start-stop behavior, long service life, reduced installation space requirements, possible pull-type and push-type clutch actuation as well as fuel economy thanks to reduced consumption because vehicles can be operated at lower rpm levels.

A DMF can only be tested on a special test bench for dual-mass flywheels. The workshop can only perform a visual inspection. The visual inspection, however, – similar to the tests on the test bench – only provides a snapshot. The assessment of such an inspection requires a great deal of expertise.

The dual-mass flywheel should be inspected each time the clutch is replaced. If the clutch has already been replaced once, the dual-mass flywheel should be replaced in any case.